NEC Univerge SV8100 Features And Specifications Manual page 536

Issue 8.01
When a cordless terminal is ringing, press the flashing function key programmed for DSS to

answer the call.
Synchronous Ringing does not apply to the cordless terminals.

A beep indicates when the cordless terminal receives off-hook ringing.

Depending on your environment, the maximum number of cordless devices used without

interference varies.
Multiple Base Units and handset units should not be closer than 20 feet anytime.

Radio interference causes interruptions in conversation. When this happens, your unit is

not defective. When noise continues, move to a different location while you talk. (You might
even need to move the base unit.) When the situation persists, contact NEC Unified
Solutions, Inc., National Technical Assistance Center (NTAC).
Environments with many metal parts, metal shelves, or metal buildings have been found to

reduce telephone performance.
term
D cordless and DECT telephones do not ring when receiving a doorbox call. Notification

is shown in the display.
term
D cordless and Cordless DECT telephones can activate the door strike relay using a

Recall key assigned in the phone configuration or, by a Flash Key assigned to one of the
line keys in Program 15-07 (751: 62) (Version 4000 or higher software is required).
The Dterm Cordless Lite II can be used in conjunction with the UNIVERGE SV8100 and

Series i Digital Multiline Telephones.
Under certain conditions, HOLD and TRANSFER have the same behavior. To prevent an

unwanted transfer after placing a call on hold and calling another user, the Line Key for the
call on hold must be pressed to retrieve the call from hold, otherwise the call is transferred
when the Cordless Terminal is returned to idle.
Dterm Cordless telephones do not support the Caller ID List feature.

The DTL-8R-1 DECT Cordless – only supports connection with DT300 terminals.

DTH-4R-1/2 Cordless – only supports connection with Series i terminals (DTH/DTR).

DTR-4R-1/2 Cordless – only supports connection with Series i terminals (DTH/DTR).

Default Setting
None
2 - 508
UNIVERGE SV8100
term
D Cordless II Terminal