Traverse With Azimuth/Bearing - Leica GPS1200 Series Technical Reference Manual

37.5.2
COGO traverse calcula-
tion with
azimuth/bearing step-
by-step
COGO

Traverse with Azimuth/Bearing

The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
1. Refer to "37.2 Accessing COGO" to access COGO Traverse Input.
COGO Traverse Input, Input page
SHIFT CONF (F2) to configure the COGO application program.
2. COGO Traverse Input, Input page
<Method: Azimuth>
<From:> The point ID of the known point for the COGO calculation.
Select a point to be used.
SURVY (F5) when <From:> is highlighted.
point for the COGO calculation.
For all point fields, the MapView interactive display on the Map page
can be used to select the desired point.
To type in coordinates for a known point open the choicelist when
<From:> is highlighted. Press NEW (F2) to create a new point.
3. COGO Traverse Input, Input page
<Azimuth:> The direction from the known point to the COGO point.
<HDist-XX:> The horizontal distance between the known point and
the COGO point.
GPS1200
manually occupy a
To
Refer to
chapter
37.3
44.3
32.5
9.3.2
813