NTRIP via Internet
34.2.3
Requirements
Use NTRIP service step-
by-step
Using the NTRIP Service with a Real-Time Rover
The configurations from the previous chapter must have been completed. Refer to "34.2.2
Configuring to Connect to a Server".
Step
Description
1.
Select Main Menu: Config...\Interfaces....
2.
In CONFIGURE Interfaces highlight Real-Time.
3.
EDIT (F3) to access CONFIGURE Real-Time Mode.
4.
CONFIGURE Real-Time Mode
<Port: NETx> must be selected.
5.
ROVER (F2) to access CONFIGURE Additional Rover Options.
6.
PAGE (F6) to access CONFIGURE Additional Rover Options, NTRIP page.
7.
CONFIGURE Additional Rover Options, NTRIP page
8.
<Use NTRIP: Yes>
<User ID:> A user ID is required to receive data from to the NTRIP Caster. Contact
the NTRIP administrator for information.
<Password:> A password is required to receive data from the NTRIP Caster.
Contact the NTRIP administrator for information.
9.
SRCE (F5) to access CONFIGURE NTRIP Source-Table.
10.
CONFIGURE NTRIP Source-Table
All MountPoints are listed. MountPoints are the NTRIP servers sending out real-
time data. This screen consists of two columns:
GPS1200
758