Leica GPS1200 Series Technical Reference Manual page 1162

Survey - General
SURVEY
Set Up Reference
Station
The settings on this screen set the reference station and its coordinates.
GPS1200
CONT (F1)
To accept changes and access the subsequent
screen. The chosen settings become active.
COORD (F2)
To view other coordinate types. Local coordi-
nates are available when a local coordinate
system is active.
LAST (F3)
To use the same coordinates as when the
receiver was last used as reference station.
Available when the receiver has previously
been used as reference station and if no point
in the active job has the same point ID as the
one last used as reference station.
Refer to paragraph "Set the reference station
coordinates step-by-step".
HERE (F4)
To use the coordinates of the current naviga-
tion position as reference station coordinates.
Refer to paragraph "Set the reference station
coordinates step-by-step".
SHIFT ELL H (F2) and SHIFT ORTH (F2)
To change between the ellipsoidal and the
orthometric height. Available for local coordi-
nates.
1162