Working Example 1 - Leica GPS1200 Series Technical Reference Manual

22.4.5
Description
Requirements
Configuration of ASCII
Input interface step-by-
step
Config...\Interfaces... - General

Working Example 1

Application:
Working technique:
Goal:
The port and the device to be used for the depth sounder is configured correctly. The device
will most likely be RS232 using the same parameters as the depth sounder. Refer to "23.2
Accessing CONFIGURE Devices / CONFIGURE GPRS Internet Devices".
Step Description
1. Refer to "22.4.1 Overview" to access CONFIGURE ASCII Input.
Survey on a small lake.
Recording the depth with the survey points.
Using a depth sounder to measure the depth of the lake at certain
locations.
The depth sounder constantly streams data at a rate of 1 Hz and
sends the depth it has measured to the GPS1200 receiver in the
format:
27.234<CR>
27.345<CR>
27.232<CR>
The ASCII Input interface needs to be configured such that when
a position is measured, the depth measurement will be stored as
annotation 1 with that point.
GPS1200 507