Leica GPS1200 Series Technical Reference Manual page 1174

Survey - General GPS1200
SHIFT ABS (F2)
To check the absolute difference between
measurements. Available for <Averaging
Mode: Absolute Diffs> and for more than one
measured coordinate triplet recorded for the
same point. Refer to "9.3.4 Mean Page".
SHIFT CONEC (F3) and SHIFT DISCO (F3)
To dial the number of the reference station
configured in the active configuration set and to
hang up immediately after the survey is
completed. Available for real-time devices of
type digital cellular phone or modem. Available
for <Auto CONEC: No> in CONFIGURE GSM
Connection.
SHIFT INIT (F4)
To select an initialisation method and to force a
new initialisation. Available for configuration
sets allowing phase fixed solutions. Refer to
"44.6 Initialisation for Real-Time Rover Opera-
tions".
SHIFT INDIV (F5) and SHIFT RUN (F5)
To change between entering an individual
point ID different to the defined ID template and
the running point ID according to the ID
template. Refer to "19.1 ID Templates".
1174