Leica GPS1200 Series Technical Reference Manual page 518

Hide thumbs Also See for GPS1200 Series:

Table of Contents

Config...\Interfaces... - General

If the time interval as defined in <Rate:> is

shorter than the epochs as defined in <Posi-

tion and Screen Update:> in CONFIGURE

Display Settings, then the internal computa-

tion of positions is changed to allow the speci-

fied rate of NMEA positions. <Position and

Screen Update:> remains unchanged.

Available for <Output: At Epoch>.

Delays the output of the NMEA message. The delay

is applied from the epoch as defined in <Rate:>. The

time of delay can be a value up to <Rate:>.

This option is required if two or more receivers are

being used to monitor the position of an object. The

position of each receiver is being output as NMEA

message back to a control station. The control station

may not be able to cope with all the positional data

messages if all receivers were sending their position

message back at exactly the same time as would be

the case with <Output: Immediately>. In this case

the output of the second receiver could be delayed so

that the control station receives the message from

each receiver at a slightly different time.

Available for <Output: On Point Stored>.

Defines the type of points for which the NMEA

message is send.

Show Quick Links

Table of Contents