Leica GPS1200 Series Technical Reference Manual page 1142

Stakeout
Step Description
7. CONT (F1) to access STAKEOUT DTM Stakeout.
8. STAKEOUT DTM Stakeout, Stake page
Check the suggested antenna height.
9. Wait until the ambiguities are solved. This is indicated by the position
status icon.
When working with code only corrections, an ambiguity solution is not
attempted.
10. STAKEOUT DTM Stakeout, Stake page
<CUT:> or <FILL:> The negative or positive height differences from
the current position to the equivalent point in the selected DTM job is
calculated and displayed. Height offsets apply.
11. Mark the current position for example with a peg.
The height difference from <CUT:> or <FILL:> may be written on the
peg.
12. OCUPY (F1) starts collecting data.
The height difference is still shown.
13. When <Auto STOP: No> in CONFIGURE Point Occupation
Settings, STOP (F1) when enough data is collected. At least one
epoch of data must be recorded.
GPS1200 1142
Refer to
chapter
19.6.1