Leica GPS1200 Series Technical Reference Manual page 1158

Survey - General GPS1200
STORE (F1)
To store the measured point. When <Auto
STORE: Yes> in CONFIGURE Point Occupa-
tion Settings, the measured point is stored
automatically. (F1) changes to OCUPY.
It may happen that a point with the same point
ID exists in the job. If the codes and/or attribute
values of the new and the existing point do not
match, a screen opens where they can be
corrected. Refer to "11.5 Code and Attribute
Mismatch".
NEAR (F2)
To compare the user's current position with the
coordinates of all points already stored in the
job and find the nearest point. This point ID is
then suggested as the next point ID to be used.
H PNT(F5)
To measure a hidden point. Refer to "46
Survey - Hidden Points".
PAGE (F6)
To change to another page on this screen.
SHIFT CONF (F2)
To configure auto points and hidden point
measurements. Accesses SURVEY Configu-
ration. Refer to "45 Survey - Auto Points".
Refer to "46 Survey - Hidden Points" for infor-
mation on the fields and keys.
1158