Leica GPS1200 Series Technical Reference Manual page 1134

Stakeout
Step Description
11. Move to the point to be staked either by following the values in the
fields <FORW:>, <BACK:>, <RGHT:> and <LEFT:> or the graphical
display.
When the value is at or nearly zero, the current position is the point
to be staked.
12. Mark the current position for example with a peg.
The height difference from <CUT:> or <FILL:> may be written on the
peg.
13. Hold the antenna steady over the marker.
14. OCUPY (F1) starts measuring the point.
The value for the stakeout elements still show the difference between
the current position and the point to be staked.
15. When <Auto STOP: No> in CONFIGURE Point Occupation
Settings, STOP (F1) when enough data is collected. At least one
epoch of data must be recorded.
For <Pos Check: Yes> and/or <Height Check: Yes> in STAKEOUT
Configuration, Checks page, a check is made on the horizontal
and/or vertical coordinate distance from the staked point to the point
to be staked. If either of the configured difference limits are exceeded,
STAKEOUT Difference Limit Exceeded is accessed.
16. When <Auto STORE: No> in CONFIGURE Point Occupation
Settings, STORE (F1) to store the point information.
GPS1200 1134
Refer to
chapter
19.6.1
43.4.5
19.6.1