Leica GPS1200 Series Technical Reference Manual page 1103

Reference Plane
Step Description
SHIFT ORIGN (F4) to use the highlighted point as the origin of the
plane.
8. PAGE (F6) to change to the Origin page.
9. REFPLANE New Reference Plane, Origin page
<Use As Origin: Plane Coords> Point results are additionally stored
with X, Y, Z coordinates based on the local plane coordinate system.
<Use As Origin: Instrumnt Coords> Points on the plane are trans-
formed into the national coordinate system.
<X-coord:> Available for <Use As Origin: Plane Coords>. Enter
local X coordinate of origin. The origin is defined as the projection of
the measured point onto the calculated plane.
<Z-coord:> Available for <Use As Origin: Plane Coords>. Enter
local Z coordinate of origin. The origin is defined as the projection of
the measured point onto the calculated plane.
<Point:> Defines the direction of the Y axis.
DIREC (F5) Available for <Point:> being hightlighted. To access
REFPLANE Survey: XX. Measure a point to define the plane direc-
tion.
10. PAGE (F6) to change to the Offset page.
11. REFPLANE New Reference Plane, Offset page
<Define Offset:> An offset can be defined by a point or a distance.
The defined plane is shifted along the Y axis by the offset.
GPS1200
Refer to
chapter
1103