Reference Line
Field procedure step-
by-step
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step
Description
1.
Refer to "41.2 Accessing Reference Line" to access REFLINE Refer-
ence Line/Arc Begin.
2.
REFLINE Reference Line/Arc Begin
Select a job and a configuration set with the settings mentioned
above.
3.
CONT (F1)
4.
REFLINE Choose Task & Reference Line, Reference page
<Task: Gridstake Line>
<Ref to Use: Select from Job>
5.
Highlight <Ref Line:>.
6.
Open the choicelist to access REFLINE Manage Reference Lines.
7.
NEW (F2) to access REFLINE New Reference Line, Input page.
8.
REFLINE New Reference Line, Input page
<Ref ID: Line001>
<Method: 2 Points>
Select the appropriate points from the choicelist.
The Map page provides an interactive display of the defined refer-
ence line.
GPS1200
1084
Refer to
chapter
41.2
41.4.3
41.4.3
32