Leica GPS1200 Series Technical Reference Manual page 406

Config...\Survey Settings...
Field procedure step-
by-step
Step Description
4. CONFIGURE Post-Process Stop Criteria
Type in how many positions are to be occupied before the point occupation stops
automatically. The number varies with each application.
5. CONT (F1) closes the screen.
6. CONT (F1) returns to the screen from where CONFIGURE Point Occupation
Settings was accessed.
Step Description
1. Refer to "44.3 Surveying Points" for accessing SURVEY Survey: Job Name.
2. At the point to be measured, place and level the pole on the point.
3. Enter a point ID.
4. If required, type in the antenna height.
5. If required, type in a code.
Point ID, antenna height and code must be correctly typed in before OCUPY (F1)
is pressed due to <Auto STORE: Yes>.
6. OCUPY (F1)
The point will be recorded and stored automatically as soon as the set number of
observations are recorded.
7. Move to the next point.
8. Repeat steps 2. to 7. until all points are measured.
GPS1200 406