Leica GPS1200 Series Technical Reference Manual page 1201

SURVEY
Survey: Job Name,
Auto page
Survey - Auto Points
The Auto page of a typical configuration set is explained. Before logging of auto points has
started, the page appears as shown below:
START (F1)
To start logging of auto points and offset points
if configured or, for <Log By: User Decides>,
to start the chain to which the auto points
should be assigned. The first auto point is
stored.
For <Start Logging: Immediately> in
SURVEY Configuration, Auto Points page,
logging of auto points starts immediately when
the SURVEY screen is accessed and START
(F1) need not be pressed.
STOP (F1)
To end recording of auto points and offset
points if configured or, for <Log By: User
Decides>, to end the chain to which the auto
points are assigned.
OCUPY (F3)
Available for STOP (F1). To store an auto point
at any time.
OFST1 (F4)
To configure recording of the first type of offset
points. Available for <Store:
DBX(Pts&Codes)> in SURVEY Configura-
tion, Auto Points page. Refer to "45.4 Offset
Points of Auto Points".
GPS1200 1201