Config...\Interfaces... - General
CONFIGURE
NMEA Messages
This screen shows the messages that can be output, which messages are currently output,
the output rates and the output timing method.
Next step
IF a NMEA message THEN
is not to be configured CONT (F1) closes the screen and returns to the screen from where
CONFIGURE NMEA Messages was accessed.
is to be configured
highlight the message and EDIT (F3). Refer to paragraph
"CONFIGURE Message to Send".
GPS1200
CONT (F1)
To accept changes and return to the screen
from where this screen was accessed.
EDIT (F3)
To configure how the currently highlighted
message is output. Refer to paragraph
"CONFIGURE Message to Send".
ALL (F4) and NONE (F4)
To activate and deactivate the output for all
messages.
USE (F5)
To activate and deactivate the output for the
highlighted message.
516