Leica GPS1200 Series Technical Reference Manual page 1101

Create reference plane
step-by-step
Reference Plane
Next step
IF
a new plane is to be
created
points are to be
measured to a plane
Step Description
1. Refer to "42.2 Accessing Reference Plane" to access REFPLANE
Reference Plane Begin.
2. CONT (F1) to access REFPLANE Choose Task & Reference
Plane.
3. REFPLANE Choose Task & Reference Plane
Select <Plane to Use: Create New Plane>.
4. CONT (F1) to access REFPLANE New Reference Plane, General
page.
NEW (F2) in REFPLANE Manage Reference Planes to
access REFPLANE New Reference Plane, General page.
5. REFPLANE New Reference Plane, General page
<Ref Plane:> The ID of the new reference plane.
<No. of Points:> Number of points used for plane definition.
THEN
CONT (F1) accesses REFPLANE New Reference Plane, General
page. Refer to paragraph "Create reference plane step-by-step".
CONT (F1) accessses REFPLANE Measure Points to Plane,
Reference page. Refer to "42.5 Measuring Points to a Reference
Plane".
GPS1200
Refer to
chapter
1101