GASOLINE VEHICLE - TRANSAXLE
FORWARD/NEUTRAL/REVERSE HANDLE
FORWARD/NEUTRAL/REVERSE HANDLE REMOVAL
1.
Remove the bolt (1) from the Forward/Neutral/Reverse handle (2) (Figure 24-14, Page 24-13).
2.
Remove the bolts (3) from the bezel (4).
3.
Remove the bezel.
FORWARD/NEUTRAL/REVERSE HANDLE INSTALLATION
1.
Install the bezel (4) and the bolts (3). Tighten the bolts to 22 lb·in (2.5 N·m) (Figure 24-14, Page 24-13).
2.
Install the Forward/Neutral/Reverse handle (2).
3.
Install the bolt (1). Tighten the bolt to 15 lb·in (1.5 N·m).
Figure 24-14 Forward/Neutral/Reverse Handle
SHIFTER CABLE
See General Warnings on page 1-2.
If the Forward/Neutral/Reverse shifter cable is damaged in any way, it must be replaced.
SHIFTER CABLE REMOVAL
NOTE: Before removing cable, note cable routing and positions of wire ties or other devices securing the cable to the
vehicle. When installed, cable must be routed and secured as it was originally.
1.
Turn the key switch to the OFF position and remove the key. Place the Forward/Neutral/Reverse handle in the
NEUTRAL position and chock the wheels.
2.
Disconnect battery and spark plug wire. See Disconnect the Battery - Gasoline Vehicles on page 1-3.
2019 Precedent,Villager 2 and 4 Maintenance and Service Manual
Forward/Neutral/Reverse Handle
24
Page 24-13