Installing The Paper Handling System - Genicom 4810 User Manual

Installing the Paper Handling System
J
-8
User's Manual
The paper handling system for this printer consist of a two-piece paper guide
and a paper shelf with wickets and a stacking aid. See Figure 1-8.
The paper shelf hangs on the back of the printer near the floor. The paper
guide hooks onto the two end wire loops protruding from the rear paper exit
and snaps into the clips on the back of the printer.
1. Hang the paper shelf on the back of the printer in the holes provided as
shown in Figure 1-8.
2. Install the wickets on the shelf so the tightening knobs are facing away
from the area the paper will occupy.
3. Slide the wickets along the shelf so the distance between the wickets
accommodates the length of your fanfold paper.
4. Lay the V-shaped paper stacking aid on the shelf between the wickets.
This stacking aid should be used when stacks of 1000 or more forms are
anticipated. See Figure 1-8.
Paper Handling System
Figure
1-8
AK37
STACKING AID
/ PAPER SHELF
Nov 93