Accessible Drives; Installing An Accessible 5 ¼-Inch Drive - Fujitsu PRIMERGY 400 Operating Manual

Accessible drives

Accessible drives
The server accommodates four accessible drives (three 5 ¼-inch drives and one 3 ½-inch drive). A
5 ¼-inch drive with a full installation height occupies two 5 ¼-inch half-height bays.
For error-free operation of SCSI hard drives it is important that each drive on the SCSI bus is
assigned a unique SCSI-ID (0 - 6) and that the matching resistor (terminator) is only connected and
enabled on the drive at the end of the SCSI cable.
As the CD-ROM drive fitted by default is connected at the end of the SCSI cable, the termination is
enabled.
Ê Please read the drive documentation.
Ê
Assign an as yet unassigned SCSI-ID to the new drive and disable the terminating resistor.
Installing an accessible 5 ¼-inch drive
Ê
Remove the control panel trim plate, the left-hand side cover and, it you wish to install an
accessible drive in the upper or middle bay, also the right-hand side cover (see "
server").
1
2
Ê
If you install a half-height drive, then remove the EMC insert from the desired bay (1) and the
plastic insert from the control panel trim plate (2).
Ê
If you install a DLT drive, then remove the two EMC inserts (1) and two plastic inserts from the
control panel trim plate (2).
A26361-K632-Z100-1-7619
2
System expansions for tower server
1
O pening the
55