Debug Platform Etherchannel - Cisco Catalyst 3750 Command Reference Manual

debug platform etherchannel

debug platform etherchannel
Use the debug platform etherchannel privileged EXEC command to enable debugging of
platform-dependent EtherChannel events. Use the no form of this command to disable debugging.
Syntax Description
init
link-up
rpc-detailed
rpc-generic
warnings
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines
The undebug platform etherchannel command is the same as the no debug platform etherchannel
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Catalyst 3750 Switch Command Reference
B-34
debug platform etherchannel {init | link-up | rpc-detailed | rpc-generic | warnings}
no debug platform etherchannel {init | link-up | rpc-detailed | rpc-generic | warnings}
Display EtherChannel module initialization debug messages.
Display EtherChannel link-up and link-down related debug messages.
Display detailed EtherChannel remote procedure call (RPC) debug messages.
Display EtherChannel RPC generic debug messages.
Display EtherChannel warning debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Catalyst 3750 Switch Debug Commands
78-16181-03