Replacing Sfp+ Transceiver Modules - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Reattach the protective optical port plug to the transceiver optical bores.
I
Place the removed SFP+ transceiver module in an antistatic bag or
other protective environment.
9.7.3

Replacing SFP+ transceiver modules

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
For Fiber Channel over Ethernet (FCoE) configurations, the ethernet server
adapter is equipped with one or two SFP+ (small form-factor pluggable)
transceiver modules.
Required tools
Preliminary and concluding steps: tool-less
●
Removing SFP+ transceiver modules: tool-less
●
Removing SFP+ transceiver modules
Ê Remove the defective SFP+ transceiver module(s) as described in section
"Removing an SFP+ transceiver module" on page
Installing SFP+ transceiver modules
Ê Unpack the new SFP+ transceiver module.
Ê Verify that the new SFP+ transceiver module is the same type of transceiver
you are replacing.
Ê Install the new SFP+ transceiver module(s) as described in section
"Installing SFP+ transceiver modules" on page
TX300 S7 / RX350 S7
Upgrade and Maintenance Manual
Expansion cards and backup units
533.
528.
535