Chapter 47 Ipv6 Route Command List (Ri And Ei Mode Only); Create Ipv6Route - D-Link xStack Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Chapter 47 IPv6 Route Command List
create ipv6route [default | <ipv6networkaddr>] [[<ipif_name 12> <ipv6addr> | <ipv6addr>]
{<metric 1-65535>} {[primary|backup]} | ip_tunnel <tunnel_name 12>]
delete ipv6route [[default | <ipv6networkaddr>] [<ipif_name 12> <ipv6addr> | <ipv6addr> |
ip_tunnel <tunnel_name 12>] | all]
show ipv6route {[<ipv6networkaddr> | <ipv6addr>]} {[static | ripng | ospfv3 | hardware]
47-1

create ipv6route

Description
This command is used to create an IPv6 static route. If the next hop is a global address, it is not
needed to indicate the interface name. If the next hop is a link local address, then the interface
name must be specified.
Format
create ipv6route [default | <ipv6networkaddr>] [[<ipif_name 12> <ipv6addr> | <ipv6addr>]
{<metric 1-65535>} {[primary|backup]} | ip_tunnel <tunnel_name 12>]
Parameters
default - Specify the default route.
<ipv6networkaddr> - Specify the destination network of the route.
<ipif_name 12> - Specify the interface for the route. This name can be up to 12 characters long.
<ipv6addr> - Specify the next hop address for this route.
<ipv6addr> - Specify the next hop address for this route.
<metric 1-65535> - (Optional) Enter the metric value here. The default setting is 1. This value
must between 1 and 65535.
primary - (Optional) Specify the route as the primary route to the destination.
backup - (Optional) Specify the route as the backup route to the destination. The backup route
can only be added when the primary route exists. If the route is not specified as the primary
route or the backup route, then it will be auto-assigned by the system. The first created is the
primary, the second created is the backup.
ip_tunnel - Specify the IP tunnel interface of the route.
<tunnel_name 12> - Enter the IP tunnel interface name.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IPv6 route:
(RI and EI Mode Only)
484