D-Link xStack Reference Manual page 524

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
are separated by a dash. For example, 1:3 would specify switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
<portlist> - Enter the list of port used for the configuration here.
state - (Optional) Enable or disable the specified link aggregation group. If not specified, the
group will keep the previous state, the default state is disabled. If configure LACP group, the
ports' state machine will start.
enable - Enable the specified link aggregation group.
disable - Disable the specified link aggregation group.
trap - (Optional) Specify the state of Link Up and Link Down notifications.
enable - Enable Link Up and Link Down notifications.
disable - Disable Link Up and Link Down notifications.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To define a load-sharing group of ports, group-id 1, master port 17 of unit 2:
DGS-3120-24TC:admin#config link_aggregation group_id 1 master_port 1:5 ports
1:5-1:7
Command: config link_aggregation group_id 1 master_port 1:5 ports 1:5-1:7
Success.
DGS-3120-24TC:admin#
51-4 config link_aggregation algorithm
Description
This command is used to configure the part of the packet examined by the Switch when selecting
the egress port for transmitting load-sharing data. This feature is available using the address-
based load-sharing algorithm, only.
Format
config link_aggregation algorithm [mac_source | mac_destination | mac_source_dest |
ip_source | ip_destination | ip_source_dest | l4_src_port | l4_dest_port | l4_src_dest_port]
Parameters
mac_source - Indicates that the Switch should examine the MAC source address.
mac_destination - Indicates that the Switch should examine the MAC destination address.
mac_source_dest - Indicates that the Switch should examine the MAC source and destination
address.
ip_source - Indicates that the Switch should examine the IP source address.
ip_destination - Indicates that the Switch should examine the IP destination address.
ip_source_dest - Indicates that the Switch should examine the IP source address and
destination address.
l4_src_port - Indicates that the Switch should examine the TCP/UDP source port.
l4_dest_port - Indicates that the Switch should examine the TCP/UDP destination port.
l4_src_dest_port - Indicates that the Switch should examine the TCP/UDP source port and
519