D-Link xStack Reference Manual page 269

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
22-28 debug ospf clear counter (RI Mode Only)
Description
This command is used to reset the OSPF statistic counters.
Format
debug ospf clear counter {packet | neighbor | spf}
Parameters
packet - (Optional) Specify to reset the OSPF packet counter.
neighbor - (Optional) Specify to reset the OSPF neighbor event counter.
spf - (Optional) Specify to reset the OSPF SPF event counter.
If the parameter is not specified, all OSPF counters will be cleared.
Restrictions
Only Administrator level can issue this command.
Example
To clear all OSPF statistic counters:
DGS-3120-24TC:admin#debug ospf clear counter
Command: debug ospf clear counter
Success.
DGS-3120-24TC:admin#
22-29 debug ospf log state (RI Mode Only)
Description
This command is used to enable or disable the OSPF debug log.
Format
debug ospf log state [enable | disable]
Parameters
enable - Specify that the OSPF debug log state will be enabled.
disable - Specify that the OSPF debug log state will be disabled.
Restrictions
Only Administrator level can issue this command.
264