D-Link xStack Reference Manual page 620

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
DGS-3120-24TC:admin#
state enable
Command: config mld_snooping data_driven_learning vlan default state enable
Success.
DGS-3120-24TC:admin#
62-16 config mld_snooping data_driven_learning
max_learned_entry (EI and SI Mode Only)
Description
This command is used to configure the maximum number of groups that can be learned by data
driven.
When the table is full, the system will stop the learning of the new data-driven groups. Traffic for
the
Format
config mld_snooping data_driven_learning max_learned_entry <value 1-1024>
Parameters
max_learned_entry - Specify the maximum number of groups that can be learned by data
driven. The suggested default setting is 56. This default setting may vary depending on
project.
<value 1-1024> - Enter the maximum learned entry value here. This value must be between 1
and 1024.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the maximum number of groups that can be learned by data driven:
DGS-3120-24TC:admin# config mld_snooping data_driven_learning max_learned_entry
50
Command: config mld_snooping data_driven_learning max_learned_entry 50
Success.
DGS-3120-24TC:admin#
62-17 clear mld_snooping data_driven_group (EI and SI Mode Only)
Description
This command is used to delete the MLD snooping groups learned by data driven.
config mld_snooping data_driven_learning vlan default
615