D-Link xStack Reference Manual page 303

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Format
show dhcp_relay {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specify the IP interface name.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no parameter is specified , the system will display all DHCP relay configuration.
Restrictions
None.
Example
To display DHCP relay configuration:
DGS-3120-24TC:admin#show dhcp_relay ipif System
Command: show dhcp_relay ipif System
DHCP/BOOTP Relay Status
DHCP/BOOTP Hops Count Limit
DHCP/BOOTP Relay Time Threshold : 2
DHCP Vendor Class Identifier Option 60 State: Disabled
DHCP Client Identifier Option 61 State: Disabled
DHCP Relay Agent Information Option 82 State
DHCP Relay Agent Information Option 82 Check
DHCP Relay Agent Information Option 82 Policy : Replace
DHCP Relay Agent Information Option 82 Remote ID : default(00-01-02-03-04-00)
DHCP Relay Agent Information Option 82 Circuit ID : default
Interface Server 1
------------ --------------- --------------- --------------- ---------------
System 10.43.21.12
DGS-3120-24TC:admin#
25-9 config dhcp_relay option_60
Description
This command is used to decide whether DHCP relay will process the DHCP option 60 or not.
When option_60 is enabled, if the packet does not have option 60, then the relay servers cannot
be determined based on option 60. The relay servers will be determined based on either option 61
or per IPIF configured servers.
If the relay servers are determined based on option 60 or option 61, then per IPIF configured
servers will be ignored.
: Disabled
: 4
: Disabled
: Disabled
Server 2 Server 3
298
Server 4