Chapter 11 Auto-Configuration Command List; Enable Autoconfig; Disable Autoconfig - D-Link xStack Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Chapter 11 Auto-Configuration

enable autoconfig

disable autoconfig

show autoconfig
11-1 enable autoconfig
Description
This command is used to enable auto configuration. When enabled, during power on initialization,
the Switch will get configure file path name and TFTP server IP address from the DHCP server.
Then, the Switch will download the configuration file from the TFTP server for configuration of the
system.
Format
enable autoconfig
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable autoconfig:
DGS-3120-24TC:admin# enable autoconfig
Command: enable autoconfig
Success.
DGS-3120-24TC:admin#
11-2 disable autoconfig
Description
This command is used to disable auto configuration. When disabled, the Switch will configure itself
using the local configuration file
Command List
151