Chapter 87 Routing Command List - D-Link xStack Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide

Chapter 87 Routing Command List

create iproute [default | <network_address>] [<ipaddr> {<metric 1-65535>} {[primary | backup |
weight <value 1-4>]} | null0 | ip_tunnel <tunnel_name 12>]
delete iproute [default | <network_address>] [<ipaddr> | null0 | ip_tunnel <tunnel_name 12>]
show iproute {[<network_address> | <ipaddr>]} {[static | rip | ospf | hardware]}
config route preference [static | default | rip | ospfIntra | ospfInter | ospfExt1 | ospfExt2] <value 1-
999> (RI and EI Mode Only)
create route redistribute dst ospf src [local | static | rip] {mettype [1 | 2] | metric <value 0-
16777214> | route_map <map_name 16>}
config route redistribute dst ospf src [local | static | rip] {mettype [1 | 2] | metric <value 0-
16777214> | [route_map <map_name 16> | no_route_map]}
delete route redistribute dst ospf src [local | static | rip]
create route redistribute dst rip src [local | static | ospf [all | internal | external | type_1 | type_2 |
inter+e1 | inter+e2]] {metric <value 0-16> | route_map <map_name 16>}
config route redistribute dst rip src [local | static | ospf [all | internal | external | type_1 | type_2 |
inter+e1 | inter+e2]] {metric <value 0-16> | [route_map <map_name 16> | no_route_map]}
(RI Mode Only)
delete route redistribute dst rip src [local | static | ospf]
show route redistribute
show route redistribute dst ospf {src [local | static | rip]}
show route redistribute dst rip {src [local | static | ospf]}
config ecmp algorithm {ip_destination | [ip_source | crc_low | crc_high] | tcp_udp_port}
and EI Mode Only)
show ecmp algorithm
show ipfdb {[ip_address <ipaddr> | interface <ipif_name 12> | port <port>]}
show route preference {[local | static | default | rip | ospf | ospfIntra | ospfInter | ospfExt1 |
ospfExt2]} (RI and EI Mode Only)
enable ecmp ospf
disable ecmp ospf
87-1 create iproute
Description
This command is used to create an IP static route.
Selecting "primary" or "backup" means the newly created route is a floating static route.
If none of the following, "primary" or "backup", is selected, the default route will:
1. be primary if there is no primary route that has the same destination;
2. be backup if there has been a primary route that has the same destination.
3. fail to create if there have been a primary route and a backup route that have the same
destination.
4. fail to create if there has been one static multipath route that has the same destination.
It will fail if a user wants to create a floating static route and there has been one static multipath
route with the same destination.
It will fail if a user wants to create a static multipath route and there has been a floating static route,
whether primary or backup.
(RI Mode Only)
(RI and EI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
836
(RI Mode Only)
(RI