D-Link xStack Reference Manual page 248

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
debug vrrp log state [enable | disable]
debug vrrp show counter
debug vrrp show flag
debug vrrp show log state
debug vrrp state [enable | disable]
debug pim ssm (RI Mode Only)
no debug pim ssm
22-1 debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Parameters
dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - Specify the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters
long.
Restrictions
Only Administrator-level users can issue this command.
Example
To dump the error log:
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
(RI Mode Only)
243