Config Loopdetect Log - D-Link xStack Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To specify that traps will be sent when the loop condition is detected or cleared:
DGS-3120-24TC:admin# config loopdetect trap both
Command: config loopdetect trap both
Success.
DGS-3120-24TC:admin#
53-8

config loopdetect log

Description
This command is used to configure the log state for LBD. The default value is enabled.
Format
config loopdetect log state [enable | disable]
Parameters
state - Specify the state of the LBD log feature.
enable - Enable the LBD log feature.
disable - Disable the LBD log feature. All LBD-related logs will not be recorded.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the log state for LBD:
DGS-3120-24TC:admin# config loopdetect log state enable
Command: config loopdetect log state enable
Success.
DGS-3120-24TC:admin#
555