D-Link xStack Reference Manual page 645

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Parameters
multicast_vlan - The name of the multicast VLAN to be configured.
<vlan_name 32> - Enter the VLAN here. The VLAN name can be up to 32 characters long.
add - Specify that the entry will be added to the specified multicast VLAN.
delete - Specify that the entry will be deleted to the specified multicast VLAN.
member_port - A member port or range of member ports to be added to the multicast VLAN.
The specified range of ports will become untagged members of the multicast VLAN.
<portlist> - Enter the list of port to be configured here.
source_port - A port or range of ports to be added to the multicast VLAN.
<portlist> - Enter the list of port to be configured here.
untag_source_port - Specify the source port or range of source ports as untagged members of
the multicast VLAN. The PVID of the untagged source port is automatically changed to the
multicast VLAN. Source ports must be either tagged or untagged for any single multicast
VLAN, i.e. both types cannot be members of the same multicast VLAN.
<portlist> - Enter the list of port to be configured here.
tag_member_port - Specify the port or range of ports that will become tagged members of the
multicast VLAN.
<portlist> - Enter the list of port to be configured here.
state - Used to specify if the multicast VLAN for a chosen VLAN should be enabled or disabled.
enable - Specify to enable the multicast VLAN for a chosen VLAN.
disable - Specify to disable the multicast VLAN for a chosen VLAN.
replace_source_ip - Before forwarding the report packet sent by the host, the source IP address
in the join packet must be replaced by this IP address. If none is specified, the source IP
address will not be replaced.
<ipaddr> - Enter the replace source IP address here.
none - Specify for not replacing the source IP address.
remap_priority - The remap priority value to be associated with the data traffic to be forwarded
on the multicast VLAN. If none is specified, the packet's original priority is used. The default
setting is none.
<value 0-7> - Enter the remap priority value here. This value must be between 0 and 7.
none - Specify that the remap priority value will be set to none.
replace_priority - (Optional) Specify that the packet priority will be changed to the
remap_priority, but only if remap_priority is set.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an IGMP snooping multicast VLAN with the name "v1", make ports 1 and 3 members
of the VLAN, and set the state to enable:
DGS-3120-24TC:admin#
1,3 state enable
Command: config igmp_snooping multicast_vlan v1 add member_port 1,3 state
enable
Success.
DGS-3120-24TC:admin#
config igmp_snooping multicast_vlan v1 add member_port
640