D-Link xStack Reference Manual page 762

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Example
To display the C-BSR settings:
DGS-3120-24TC:admin#show pim cbsr
Command: show pim cbsr
PIM Candidate-BSR Table
C-BSR Hash Mask Len
C-BSR Bootstrap Period
Interface IP Address
------------ ------------------ -------------
System 10.90.90.90/8
Total Entries: 1
DGS-3120-24TC:admin#
79-8 config pim crp
Description
This command is used to configure the RP (Rendezvous Point) candidate feature and parameters
used by this Switch. The elected RP, for a specific multicast group, will receive requested multicast
traffic from the DR (Designated Router) and will forward this to the multicast receiver(s) requesting
the traffic. In a multicast group only one active RP can exist. All other RPs will be configured as
candidate RPs.
Format
config pim crp {holdtime <value 0-255> | priority <value 0-255> | wildcard_prefix_cnt [0 | 1]}
Parameters
holdtime - (Optional) This field is used to set the time Candidate RP (CRP) advertisements are
valid on the PIM-SM enabled network. If CRP advertisements are not received by the BSR
within this time frame, the CRP is removed from the list of candidates. An entry of 0 will send
out one advertisement that states to the BSR that it should be immediately removed from CRP
status on the PIM-SM network.
<value 0-255> - Enter the hold time for the RP here. This value must be between 0 and 255.
The default value is 150 seconds.
priority - (Optional) Specify the priority used for RP election. This priority value will be included in
the router's CRP advertisements. A lower value means a higher priority, yet, if there is a tie for
the highest priority, the router having the higher IP address will become the RP.
<value 0-255> - Enter the priority value used here. This value must be between 0 and 255.
The default value is 192.
wildcard_prefix_cnt - (Optional) Specify the Prefix Count value of the wildcard address
(224.0.0.0/24) to be choosed. The default vaule is 0.
0 - Specify that the wildcard prefix count value will be set to 0.
1 - Specify that the wildcard prefix count value will be set to 1.
: 30
: 60
Priority
255
757