Show Igmp - D-Link xStack Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
state - Specify the IGMP state on a router interface.
enable - Specify that the IGMP state will be enabled.
disable - Specify that the IGMP state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable IGMP version 1 for the IP interface "System":
DGS-3120-24TC:admin#config igmp ipif System version 1 state enable
Command: config igmp ipif System version 1 state enable
Success.
DGS-3120-24TC:admin#
To configure IGMPv2 for all IP interfaces:
DGS-3120-24TC:admin#config igmp all version 2
Command: config igmp all version 2
Success.
DGS-3120-24TC:admin#
39-2

show igmp

Description
This command is used to display the IGMP configuration.
Format
show igmp {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specify the IP interface name to be displayed.
<ipif_name 12> - Enter the IP interface name, to be displayed, here. This name can be up to
12 characters long.
If no parameter is specified, the system will display all IGMP configurations.
Restrictions
None.
Example
To display the IGMP configuration for all interfaces:
401