D-Link xStack Reference Manual page 427

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Example
To delete an IGMP snooping static group for VLAN 1, group 239.1.1.1:
DGS-3120-24TC:admin# delete igmp_snooping static_group vlan default 239.1.1.1
Command: delete igmp_snooping static_group vlan default 239.1.1.1
Success.
DGS-3120-24TC:admin#
41-11 config igmp_snooping static_group
Description
This command is used to configure IGMP snooping static group. When a port is configured as a
static member port, the IGMP protocol will not operate on this port. For example, suppose that a
port is a dynamic member port learned by IGMP. If this port is configured as a static member later,
then the IGMP protocol will stop operating on this port. The IGMP protocol will resume once this
port is removed from static member ports.
The static member port will only affect V2 IGMP operation.
Format
config igmp_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipaddr>
[add | delete] <portlist>
Parameters
vlan - Specify the name of the VLAN on which the static group resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID here.
<ipaddr> - Specify the multicast group IP address (for Layer 3 switch).
add - Specify to add the member ports.
delete - Specify to delete the member ports.
<portlist> - Specify a range of ports to be configured.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To unset port range 9-10 from IGMP snooping static member ports for group 239.1.1.1 on default
VLAN:
422