D-Link xStack Reference Manual page 503

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
need to be able to have access to accomplish authentication. Before the client passes
authentication, it should be added to the Switch with its IP address. For example, the client may
need to access update.microsoft.com or some sites of the Anti-Virus software companies to check
whether the OS or Anti-Virus software of the client are the latest; and so IP addresses of
update.microsoft.com and of Anti-Virus software companies need to be added in the Switch.
Format
config jwac update_server [add | delete] [ipaddress <network_address> | ipv6address
<ipv6networkaddr>] {[tcp_port <port_number 1-65535> | udp_port <port_number 1-65535>]}
Parameters
add - Specify to add a network address to which the traffic will not be blocked. Up to 100 network
addresses can be added.
delete - Specify to delete a network address to which the traffic will not be blocked.
ipaddress - Specify the network address to add or delete.
<network_address> - Enter the network address here.
ipv6address - Specify the IPv6 network address for the update server network. (EI Mode Only)
<ipv6networkaddr> - To set a specific IPv6 network address, use "/" to separate the IPv6
address and the number of network mask bits. If TCP port or UDP port number is not
specified, all TCP/UDP ports are accessible.
tcp_port - (Optional) Specify a TCP port number between 1 and 65535.
<port_number 1-65535> - Specify a TCP port value between 1 and 65535.
udp_port - (Optional) Specify a UDP port number between 1 and 65535.
<port_number 1-65535> - Specify a UDP port value between 1 and 65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the update servers:
DGS-3120-24TC:admin#config jwac update_server add ipv6address 3000::1/32
Command: config jwac update_server add ipv6address 3000::1/32
Update Server 3000::/32 is added.
Success.
DGS-3120-24TC:admin#
48-17 config jwac switch_http_port
Description
This command is used to configure the TCP port which the JWAC switch listens to. This port
number is used in the second stage of the authentication. PC users will connect to the page on the
Switch to input the user name and password. If not specified, the default port number is 80. If no
protocol is specified, the protocol is HTTP.
HTTP cannot run on TCP port 443, and HTTPS cannot run on TCP port 80.
498