Srm (Ei Mode Only); Srm Settings - D-Link xstack DES-3810 series Reference Manual

®
xStack DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Management
Configuration
Network Monitoring
Community Strings and Trap Stations
Update Firmware and Configuration Files
System Utilities
Factory Reset
User Account Management
Add/Update/Delete User Accounts
View User Accounts
The fields that can be configured are described below:
Parameter
User Name
Password
Confirm Password
Access Right
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specified entry.
Click the Delete button to remove the specified entry.
NOTICE: In case of lost passwords or password corruption, please refer to the appendix chapter
entitled, "Password Recovery Procedure," which will guide you through the steps necessary to
resolve this issue.
NOTE: The username and password should be less than 16 characters.

SRM (EI Mode Only)

SRM Settings

This window is used to configure the Switch Resource Management (SRM) configured mode. Only after the
Switch has been rebooted, will this configuration take effect.
To view this window, click System Configuration > SRM > SRM Settings as shown below:
The fields that can be configured are described below:
Parameter
Admin
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Description
Here the user can type in a new user name for the switch.
Here the user can type in a new password for the switch.
Here the user can re-type in a new password for the switch.
Here the user can specify the access right for this user.
Figure 2-25 SRM Settings window
Description
Operator
Read/Write–partly
Read/Write
Read-only
No
No
No
No
No
22
User
No
Read-only
Read-only
No
No
No
No
No