D-Link xStack Reference Manual page 846

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
87-6 config route redistribute dst ospf src (RI Mode Only)
Description
This command is used to update the metric or the route map to be associated with the
redistributed routes from a specific protocol to OSPF protocol.
Format
config route redistribute dst ospf src [local | static | rip] {mettype [1 | 2] | metric <value 0-
16777214> | [route_map <map_name 16> | no_route_map]}
Parameters
local - Redistribute local routes into OSPF.
static - Redistribute static routes into OSPF.
rip - Redistribute RIP routes into OSPF.
mettype - (Optional) Allow the selection of one of two methods for calculating the metric value.
1 - 1 calculates the metric (for other routing protocols to OSPF) by adding the destination's
interface cost to the metric entered in the Metric field.
2 - 2 uses the metric entered in the Metric field without change. This field applies only when
the destination field is OSPF. If the metric type is not specified, it will be type 2.
metric - (Optional) Specify the metric for the redistributed routes.
<value 0-16777214> - Enter the value between 0 and 16777214. If it is not specified or
specified as 0, the redistributed routes will be associated with the default metric 20.
route_map - (Optional) Specify the route map for the redistributed routes.
<map_name 16> - Enter the name of the route map.
no_route_map - (Optional) Specify to remove the route map associated with the redistributed
routes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure route redistributions:
DGS-3120-24TC:admin#config route redistribute dst ospf src rip mettype 1 metric
2
Command: config route redistribute dst ospf src rip mettype 1 metric 2
Success.
DGS-3120-24TC:admin#
87-7 delete route redistribute dst ospf src (RI Mode Only)
Description
This command is used to stop redistribution of routes from one source protocol to OSPF.
841