D-Link xStack Reference Manual page 124

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Parameters
profile_id - (Optional) Specify the profile ID.
<value 1-6> - Enter the profile ID used here. This value must be between 1 and 6. A lower
value denotes a higher priority.
profile_name - (Optional) Specify the name of the profile. The maximum length is 32 characters.
<name 1-32> - Enter the profile name used here.
access_id - (Optional) Specify the access ID.
<value 1-256> - Enter the access ID used here. This value must be between 1 and 256. A
lower value denotes a higher priority.
Restrictions
None.
Example
To display the flow metering configuration:
DGS-3120-24TC:admin# show flow_meter
Command: show flow_meter
Flow Meter Information
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:1
CIR(Kbps):1000
Action:
Conform : Permit
Exceed : Permit
Violate : Drop
------------------------------------------------------------------------------
Total Entries: 1
DGS-3120-24TC:admin#
6-7 config time_range
Description
This command is used to define a specific range of time to activate a function on the Switch by
specifying which time range in a day and which days in a week are covered in the time range. Note
that the specified time range is based on the SNTP time or the configured time. If this time is not
available, the time range will not be met.
Format
config time_range <range_name 32> [hours start_time <time hh:mm:ss> end_time <time
hh:mm:ss> weekdays <daylist> | delete]
Parameters
time_range - Specify the name of the time range settings.
<range_name 32> - Enter the time range name used here. This name can be up to 32
characters long.
Mode : trTCM / ColorBlind
CBS(Kbyte):2000
Replace DSCP: 60
119
PIR(Kbps):2000
Counter: Enabled
Counter: Enabled
Counter: Disabled
PBS(Kbyte):2000