Cutter Replacement; Removing The Cutter; Installing A New Cutter - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.1.4 Cutter Replacement

When removing the cutter, be careful not to drop it.
C A U T I O N
1. Remove the Front Cover. (p142)
2. Open the Cutter Cover.
3. Loosen the screw that secures the cutter, and remove the cutter.
A) Silver, Phillips, Bind P-tite M4x10: one piece
Cutter Cover
Figure 3-17. Removing the Cutter
DISASSEMBLY & ASSEMBLY
Cutter
A
Disassembly and Assembly Procedure
4. Set the positioning holes of the new cutter to the bosses of the main body.
Positioning holes
Cutter
Figure 3-18. Installing a new cutter
When securing the cutter in the next step, be sure to secure it
C A U T I O N
firmly. Otherwise, the cutting position may be misaligned or
skewed.
5. Secure the cutter with the screw.
6. Close the Cutter Cover. See Figure 3-17.
7. Set the Front Cover, and secure it with the four screws.
Revision A
Bosses
See Figure 3-17.
See Figure 3-17.
Confidential
127