Cutter Replacement Menu - Epson StylusPRO 7000 Service Manual

EPSON Stylus Pro 7000
5. Print the paper thickness pattern, and enter the number of the vertically
aligned pair of lines. (#5 is correct in the example below.).
A4 printable
area
The numbers above represent
0.1mm increments between the
head and platen, with "1" being
0.0mm and "17" being 1.6mm.
6. Set the ink drying period, 0~30 minutes.
7. Make the paper-suction fan setting; Norm (normal) or Low.
Product Description

1.6.5 Cutter Replacement Menu

Print the Status Sheet from the Test Print menu in SelecType mode and see
page 44 for information on determining when the cutter needs to be replaced.
The following table includes the steps/messages that must be followed to
replace the cutter.
OPEN LOWER COVER
REPLACE CUTTER
CLOSE LOWER COVER
If you need to replace the cutter:
1. Press the SelecType button to enter SelecType mode, and select the
cutter replacement menu. (You can automatically enter the cutter
replacement menu by pressing the SelecType button for five seconds.)
2. Open the Lower Cover (as shown on the LCD).
Select the number of
3. While pushing down the cutter (the lower of the two extensions on the
the set of lines that is
left), slide the cutter actuator extension up and to the right.
vertically aligned.
4. Remove the old cutter and replace with a new one.
5. Close the Lower Cover (as shown on the LCD).
SelecType Settings
Table 1-37. Cutter Replace Menu
Display Message Item
CUT. REPLACE EXEC.
-
-
-
Revision A
Notes
Prepare a replacement cutter and
Open the front cover.
Remove the old cutter and install a
new one.
Close the front cover. The printer is
ready.
46