Cutter Replacement Menu - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500

1.6.5 Cutter Replacement Menu

Replacement of the cutter is determined by the settings in the cutter replacement menu.
Each setting is made using the following panel button operations.
o
Cutter Replacement Menu Selection:
o
Replacing the cutter:
o
Changing the Setting Value:
o
Setting the Set Value:
Mode End:
By running this mode, the cutter can be replaced. The setting method is as shown below.
1) Enter the Cutter Replacement Menu by the panel. (You can also enter the cutter
replacement menu by pressing the SelecType button for 5 seconds or longer.)
2) Open the front cover.
3) Replace the cutter.
4) Close the front cover.
The cutter replacement procedure is shown in the following table.
Table 1-36. Cutter Replacement Operation Procedure
Display Setting Value
CUT. REPLACE EXEC.
OPEN LOWER
–
COVER
REPLACE CUTTER –
CLOSE LOWER
–
COVER
Product Description
See the panel setting menu
procedure.
Paper Source button
"+" or "–" button.
"Enter" button
"Pause" button.
Contents
Sets the printer in a state where it is possible to
perform the cutter replacement operation.
Open the lower cover and carry out the
replacement operation.
Cutter replacement.
Close the lower cover. That terminates the
operation.
Panel Setting Menu
Revision A
46