EPSON Stylus Photo R340/350
2.3.2 Removing the Left Housing
C.B.P 3x8 (6-8kgf.cm)
Left Housing (inside)
Figure 2-3. Removing the Left Housing
Disassembly and Assembly
Left Side of
Parts/Components must be removed to remove the Left Housing.
Remove the screw (
Open the Printer Cover.
Release the hooked tab of the Lower Housing from inside the housing, and
then push the Left Housing toward the rear of the printer to release the nine
tabs ( ), and remove the Left Housing.
Make sure there is no gap between the Left Housing and the Upper
) that secures the Left Housing.
Should be no gap
Figure 2-4. Reinstalling the Left Housing