Manual Processing Of Copy Sets And Covers Removed During Jam Clearance - Oce DFS10 Operator's Manual

Manual processing of copy sets and
covers removed during jam clearance
58
During jam clearance, do not discard copy sets and covers
removed from the DFS10. Unless they are damaged, you can
use the Manual Feeder to process them into bound books. To
do so, perform the following procedure:
Copy sets and covers removed from the DFS10
1. Verify that the copy set and cover are undamaged and
complete.
2. Manually insert the copy set into the cover according to
the page orientation.
3. Open the Manual Feeder door.
4. Insert the copy set with cover into the Manual Feeder.
NOTE: Follow the directions on the labels adjacent to the
Manual Feeder area of the DFS10 for the correct
positioning of the copy set with cover.
5. Select (None) as the cover source from the Cover
Supply section on the Control Panel on the DFS10.
NOTE: If no cover was present in the DFS10, insert just
the copy set into the Manual Feeder. Follow the directions
on the labels adjacent to the Manual Feeder area of the
DFS10 for the correct positioning of the copy set without
cover. Select the desired Cover Tray for automatic
insertion of the cover.
6. Press the Manual Start button on the Control Panel of the
DFS10.
7. Retrieve the book from the Output Tray of the DFS10 after
the binding process has completed.
Note: Refer to chapter 3, "Making the books", for
complete information about using the Manual Feeder to
bind copy sets with covers.
Problem solving