Lsanzoneshow - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

lsanZoneShow

lsanZoneShow
Displays logical SAN zone information.
SYNOPSIS
lsanzoneshow [-s] [-f fabricid] [-w wwn] [-z zonename]
DESCRIPTION
Use this command to display the inter-fabric zones or LSAN zones. These zones are normal WWN
zones created in FC Router EX_Port-connected fabrics and backbone fabrics. The LSAN zones are
identified by the text string "lsan_" in the zone name. Note that the string is case insensitive so "LSAN_"
also is valid. The FC Router uses these zones to establish the inter-fabric device import and export
policy. The LSAN zones are established by zoning administration in each EX_Port-attached fabric and
backbone fabric. Inter-fabric device sharing is allowed between two devices if the LSAN zones defined in
their respective fabrics both allow the two devices to communicate; for example, the intersection of LSAN
zones in two fabrics define the device sharing policy.
The LSAN zones are listed by fabric. Zone membership information (information about the devices in the
zone) is provided for each LSAN zone. The default output displays only WWNs of the zone members.
Search parameters -f, -w, and -z allow searching for LSAN zones based on fabric ID, WWN of an LSAN
zone member, or LSAN zone name.
"No LSAN zone found" is displayed if there is no LSAN zone information available at this FC Router.
Each LSAN zone entry displays the following:
Fabric ID
Zone Name
Zone Members
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
-s state
-f fabricid
500
The ID of the fabric in which the LSAN zone was created.
The zone name.
The zone members or devices. The default output displays the WWN of the zone
members.
Displays state information for the device. Valid states include the following:
Configured
Device is configured to be in an LSAN, but the device is neither imported nor
exists in this fabric.
Initializing
Device is in an intermediate state. It is not yet imported into the fabric.
EXIST
Device exists in this fabric (the fabric of the zone entry).
Imported
Device has been imported (proxy created) into this fabric.
Displays LSAN zones in the specified fabric.
Fabric OS Command Reference
53-1001764-01