Port Mirroring Commands; Enable Mirror; Disable Mirror - D-Link DGS-1210/ME series Reference Manual

The Port Mirroring commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

enable mirror

disable mirror

config mirror target
delete mirror
show mirror
Each command is listed in detail, as follows:
enable mirror
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the mirroring feature:
disable mirror
Purpose
Syntax
Description
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide

PORT MIRRORING COMMANDS

Parameter
<port 1-28> [add | delete] source ports <portlist> [both | rx | tx]
target <port> source <port>
Used to enable a previously entered port mirroring configuration.
enable mirror
The enable mirror command, combined with the disable mirror
command below, allows the user to enter a port mirroring
configuration into the Switch, and then turn the port mirroring on and
off without having to modify the port mirroring configuration.
None.
Only Administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5# enable mirror
Command: enable mirror
Success.
DGS-1210-28P/ME:5#
Used to disable a previously entered port mirroring configuration.
disable mirror
The disable mirror command, combined with the enable mirror
command above, allows the user to enter a port mirroring
configuration into the Switch, and then turn the port mirroring on and
off without having to modify the port mirroring configuration.
218
29