Chapter 36
Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 36-23
OS/390
VTCS
Note
For information about FCIP tape acceleration, see
Configuring FICON Tape Acceleration
FICON tape acceleration has the following configuration considerations:
•
•
•
•
•
To configure FICON tape acceleration over FCIP in Fabric Manager, follow these steps:
Expand ISL and then select FCIP in the Physical Attributes pane.
Step 1
Step 2
Click the Tunnels tab in the Information pane.
You see a list of available switches
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Host Accessing Peer-to-Peer VTS (Virtual Tape Server)
VTSS
FICON
Over FCIP
VTSS
In addition to the normal FICON configuration, FICON tape acceleration must be enabled on both
ends of the FCIP interface. If only one end has FICON tape acceleration enabled, acceleration does
not occur.
FICON tape acceleration is enabled on a per VSAN basis.
FICON tape acceleration cannot function if multiple ISLs are present in the same VSAN
(PortChannels or FSPF load balanced).
You can enable both Fibre Channel write acceleration and FICON tape acceleration on the same
FCIP interface.
Enabling or disabling FICON tape acceleration disrupts traffic on the FCIP interface.
349x
Tape Lib
FICON
Over FCIP
349x
Tape Lib
"FCIP Tape Acceleration" section on page
(Figure
36-24).
Cisco MDS 9000 Family CLI Configuration Guide
FICON Tape Acceleration
48-32.
36-35