Configuring Default Zone Qos Priority Attributes - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Advanced Zone Attributes
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 30-32
Use the check boxes and drop-down menus to configure QoS on the default zone.
Step 3
Step 4 Click Apply Changes to save the changes.

Configuring Default Zone QoS Priority Attributes

QoS priority attribute configuration changes take effect when you activate the zone set of the associated
zone.
Note If a member is part of two zones with two different QoS priority attributes, the higher QoS value is
implemented. This situation does not arise in the VSAN-based QoS as the first matching entry is
implemented.
To configure the QoS priority attributes for a default zone using Fabric Manager, follow these steps:
Step 1 Choose Zone > Edit Local Full Zone Database.
You see the Select VSAN dialog box.
Step 2 Select a VSAN and click OK.
You see the Edit Local Full Zone Database dialog box for the selected VSAN.
Choose Edit > Edit Default Zone Attributes to configure the default zone QoS priority attributes (see
Step 3
Figure
Figure 30-33
Step 4 Check the Permit QoS Traffic with Priority check box and set the Qos priority drop-down menu to low,
medium, or high.
Cisco MDS 9000 Family CLI Configuration Guide
30-34
Zone Policies Tab in the Information Pane
30-33).
QoS Priority Attributes
Chapter 30 Configuring and Managing Zones
OL-16184-01, Cisco MDS SAN-OS Release 3.x