HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 1007

Chapter 50 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Caution Enabling the proxy initiator mode of an iSCSI interface that is part of an iSLB VRRP group impacts load
balancing on the interface. See the
Balancing" section on page
To configure the proxy initiator using Fabric Manager, follow these steps:
Step 1 Expand Switches, expand Interfaces and then select FC Logical in the Physical Attributes pane.
You see the Interface tables in the Information pane (see
Figure 50-20
In Device Manager, click Interface > Ethernet and iSCSI.
Step 2
You see the Ethernet Interfaces and iSCSI dialog box shown in
Figure 50-21
Step 3 Click the iSCSI tab in either FM or DM.
You see the iSCSI interface configuration table (see
OL-16184-01, Cisco MDS SAN-OS Release 3.x
"Changing iSCSI Interface Parameters and the Impact on Load
50-45.
FC Logical Interface Tables
Ethernet Interfaces and iSCSI Dialog Box
Figure 50-20).
Figure 50-21.
Figure 50-22).
Cisco MDS 9000 Family CLI Configuration Guide
Configuring iSCSI
50-21