Fibre Channel Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 20-2
Operational State
Down
Trunking
Reason Codes
Reason codes are dependent on the operational state of the interface as described in
Table 20-3
Administrative
Configuration
Up
Down
Up
Note
Only some of the reason codes are listed in
If the administrative state is up and the operational state is down, the reason code differs based on the
nonoperational reason code as described in
Cisco MDS 9000 Family CLI Configuration Guide
20-8
Operational States (continued)
Description
Interface cannot transmit or receive (data) traffic.
Interface is operational in TE mode.
Reason Codes for Interface States
Operational
Status
Reason Code
Up
None.
Down
Administratively down—If you administratively configure an interface
as down, you disable the interface. No traffic is received or transmitted.
Down
See
Table
20-4.
Table
20-4.
Table
20-4.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 20
Configuring Interfaces
Table
20-3.