Configuring Ethernet Portchannels; Configuring Cdp; Default Settings - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Configuring CDP

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 52-5
IPS module
In Figure
Ethernet PortChannels are not supported on MPS-14/2 modules and 9216i IPS modules.
PortChannel interfaces provide configuration options for both Gigabit Ethernet and Fibre Channel.
Note
However, based on the PortChannel membership, only Gigabit Ethernet parameters or Fibre Channel
parameters are applicable.

Configuring Ethernet PortChannels

The PortChannel configuration specified in
Ethernet PortChannel configurations.
Gigabit Ethernet interfaces cannot be added to a PortChannel if one of the following cases apply:
Note
- The interface already has an IP address assigned.
- The subinterfaces are configured on that interface.
- The interface already has an associated IPv4-ACL rule and the PortChannel does not.
Configuring CDP
The Cisco Discovery Protocol (CDP) is supported on the management Ethernet interface on the
supervisor module and the Gigabit Ethernet interfaces on the IPS module or MPS-14/2 module.
See the

Default Settings

Table 52-2
Cisco MDS 9000 Family CLI Configuration Guide
52-10
Ethernet PortChannel Scenario
Switch 1
52-5, Gigabit Ethernet ports 3 and 4 in slot 9 are aggregated into an Ethernet PortChannel.
"Configuring CDP" section on page
lists the default settings for IP storage services parameters.
Ethernet PortChannel
aggregation
L2 switch
Chapter 23, "Configuring PortChannels"
12-12.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 52 Configuring IP Storage
also applies to